Home
/
Products
/ Circular Reinforced Concrete Pipe
Long-lasting, easily installed Circular Reinforced Concrete Pipe is the right choice for applications where:
The required size is larger than available unreinforced pipe
Low, moderate or severe cover and/or live load conditions exist
Structural failure might endanger life or property — reinforced pipe does not collapse or lose its shape even after ultimate failure
Internal hydrostatic pressures (up to 65 psi) are expected
Trenchless installation is required
Applications
Reinforced Concrete Pipe is designed for:
Sanitary sewers
Storm drains
Culverts
Jacked or tunneled systems
Treatment plant piping
Sizes
Reinforced Concrete Pipe is normally available in diameters from 12 inches (300mm) through 144 inches (3600mm).
Joints
The following joints are normally available for reinforced concrete pipe:
tongue and groove with mastic or butyl sealant
concrete joint with confined O-ring gasket, rubber or neoprene
concrete joint with single-offset and profile gasket, rubber or neoprene
steel-end rings with confined O-ring gasket, rubber or neoprene (U.S. Bureau of Reclamation Joint Type R-2)
Linings/Coatings
A variety of linings and coatings are available as dictated by project conditions.
Fittings/Specials
A wide variety of fittings and specials is available to augment circular pipe. Specials include:
Tees
Wyes
Elbows
Reducers/increasers
Adapters
Applicable Specifications
ASTM C76/AASHTO M170 — Reinforced Concrete Culvert, Storm Drain and Sewer Pipe
ASTM C655 — Reinforced Concrete D-Load Culvert, Storm Drain and Sewer Pipe
ASTM C443/AASHTO M198 — Joints for Circular Concrete Sewer and Culvert Pipe Using Rubber Gaskets
CSA A257.2 — Reinforced Concrete Culvert, Storm Drain and Sewer Pipe
product sales sheet
back to top
© 2007 Hanson Pipe & Precast. All rights reserved.
Site Map
Legal
